Farmall & IHC Tractors Discussion Board |
Re: Farmall Cub governor adjustment?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George Willer on September 28, 2001 at 07:43:28 from (64.254.131.6):
In Reply to: Farmall Cub governor adjustment? posted by one - L Darrel on September 27, 2001 at 21:43:37:
Darrel, You already have 3 replies that are right on the mark. I'll add my favorite method of curing the shaft play...Locktite. Clean both parts, apply a few drops of Locktite, and assemble. In a few minutes, it will be like one piece. This method removes all play and is less likely to come loose again. In the unlikely event it will ever have to be taken apart, heating to around 400 degrees will do it. I have several that have had this treatment with good results. George Willer
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|