Farmall & IHC Tractors Discussion Board |
Problem with SC Head Gasket
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on September 26, 2001 at 21:46:54 from (66.152.73.114):
After installing a new Case/IH head gasket and a freshly rebuilt head torqued to 65 ft. lbs. on my Super C, it only took two hours to have the new anti freeze/water misture seeping out almost all the way around the head gasket and enough to make it run down the sides of the block. The tractor had not been started (Battery was low). I left it sit for two days and the seeping continued. Pulled the head back off and found a green corrosion in all the water jacket holes on the distributor side of the head gasket. No corrosion on the manifold side. Droplets of anti freeze was also present on top of the pistons. The gommets around the holes in the gasket were almost corroded away Tonight I replaced the head gasket with a new Victor torqued everything back down, changed the oil and started the tractor. No leaks! Anyone ever have this problem? Dealer is stumped just like me and the machine shop that did the head. Machine shop did hot tank the head but after that is was bead blasted and then steam cleaned so I don't think it was something in the head//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|