|
Farmall & IHC Tractors Discussion Board |
Ironguard paint and a manifold mystery
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BTD on September 24, 2001 at 04:18:42 from (192.132.24.66):
Actually, this is a two question post. I have found out with much unhappyness that gasoline is great at removing Case Ironguard paint that has been on my M for over a month now. The paint just bubbles better than if I used Easy-Off. After I repaint, does anyone know of a good product to put over the paint to seal it better and prevent the removal? With a slight drip in the carb I don't think I'll ever be able to prevent gas from touching the paint.
Second question, I have heard of a 'water drain' hole in M manifolds. My M has the original gasoline manifold and in the corner maybe an inch from where the tube connected to the carb joins the rest of the manifold, I have a decent sized hole. It's about 3/16 around. Is this the water drain I have heard about or do I have just have a hole? Exhaust blows out of the hole when running. Thanks a bunch fellas! -BTD
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
