Farmall & IHC Tractors Discussion Board |
Re: More on the 1066 not staying in reverse
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on September 10, 2001 at 21:08:00 from (216.196.12.101):
In Reply to: More on the 1066 not staying in reverse posted by Mitch Sisson on September 10, 2001 at 18:51:16:
The bushings that you are talking about sounds to me that they WERE the rollers that go on the pins in the shifter cam as far as the sheet metal with the bolt in it i would have to see it . the ft. gear should not move more them a few thousanths up to a 16th of and inch , is the rev. shifting fork look woren ? does it have any free travel? it should be tight. sometime they ware in the small key way on the shaft that goes into the fork. If this is the case then it is time for some new pices and parts.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|