Farmall & IHC Tractors Discussion Board |
Re: Belly leak on M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on September 10, 2001 at 19:01:16 from (129.37.117.118):
In Reply to: Belly leak on M posted by Leak'n M on September 10, 2001 at 14:25:30:
If you are speaking of the cover that is under the tractor just behind the belly pump, there is no fluid there except what is leaking. Take the cover off and you can look up in there and see the shaft that drives the belly pump. If you clean it up some, you should be able to see where the leak is coming from. Most likely is the belly pump shaft seal. You have to take the belly pump out to replace it. Also, the transmission counter shaft seal may be leaking. The countershaft drives the belly pump. I took my belly pump out by replacing the 3/8 bolts one at a time with threaded rods and nuts and then lowering the pump down with the nuts. You have to take all the piping conections and the operating lever out first.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|