Farmall & IHC Tractors Discussion Board |
Re: converting Super M to 12 volt wiring voltage regulator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on September 09, 2001 at 04:17:20 from (12.84.239.94):
In Reply to: converting Super M to 12 volt wiring voltage regulator posted by Carl on September 08, 2001 at 21:37:40:
Carl you will have to pull the light box apart to make sure you get the correct wire to the correct post on the VR. One wire should go from the bat. terminal to the negative post on the ampmeter. The other wire possibly goes from the L terminal on the VR to the junction box in the light box. That junction box will have both a wire going to the light switch, via the fuse, and another wire to the coil switch. The bat. terminal should be the center post of the three. You do not have to wire the lights and coil switch using the L terminal. You can run both wires off the negative side of the ampmeter which was how the early Hs and Ms were wired.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|