Farmall & IHC Tractors Discussion Board |
Re: Hole in my manifold.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith agrees with Binder on September 07, 2001 at 12:12:47 from (128.242.4.59):
In Reply to: Hole in my manifold. posted by Jeff on September 07, 2001 at 09:09:54:
I had a manifold for an H patched up by an experienced welder by brazing. I haven't had any trouble with it yet and that has been several years ago. I always park it under a roof since I repainted it at the same time. Keeping a tractor under a roof will cut way back on rust type diterioration. Except perhaps for fluid filled rear tires. That fluid is really bad when it gets in direct contact with metal.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|