Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Need some advice about the sickness.....


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Bill Smith on September 07, 2001 at 11:54:32 from (128.242.4.59):

In Reply to: Need some advice about the sickness..... posted by Chris J on September 07, 2001 at 11:04:21:

Well, an average M isn't worth much more than an average H. An average H in my area is worth around $500. An average M in my area would be around $700 or so. Smaller tractors seem to be worth more (referring to the c and smaller). Why I don't know for sure but I speculate that it is becuase they take up less space when you store them inside and perhaps fewer were made. A friend of mine has an average C and he priced it to me around a $1000 to $1500. I don't know if the offer is out of the ball park (maybe a little high) but I refuse to pay more money for a smaller sized tractor. Why pay $1500 for a C when you can buy 3 H's or 2 M's for the same money. You can get alot more done with a bigger tractor to boot. The only advantage I can see is you can drive a C into an average sized garage door. An H or an M is likely to hit exhaust pipe or steering wheel on the top of door and will take up more space inside your 2 car garage. I sawed the exhaust pipe off of my H so it will fit into an average door. But now I store it in bigger shed. An M would be a little taller and what not. Alot of people get there mind set on smaller tractors or want one of each size and therefore look pretty hard at smaller tractors, while loosing sight of bigger tractors selling cheaper. A C would be maybe more convenient for the boy to work on since the parts would be lighter. As far as turning him loose driving one, if he is old enough, it wouldn't be much more dangerous than having him drive one bigger than a C. I was driving an H and M as soon as my legs were long enough to push the clutch in. Just my 2 cents worth.


Follow Ups:




Post A Followup

:
:

: Re: Re: Need some advice about the sickness.....

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy