Farmall & IHC Tractors Discussion Board |
Re: Farmall M engine stuck
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ELTON on August 30, 2001 at 21:21:14 from (63.22.231.79):
In Reply to: Farmall M engine stuck posted by bama mule on August 29, 2001 at 19:00:58:
I HAD A TD35 THAT HAD SAT FOR ABOUT 7 YEARS AND I WAS ABLE TO GET IT UNSTUCK. THERE WASN'T ANY CYLINDER DAMAGE BUT THE VALVES THAT ARE OPEN WILL RUST ON THE SEAT AND GIVE YOU POOR COMPRESSION. IN OTHER WORDS YOU MAY HAVE TO PULL THE HEAD ANY WAY. THE BUSTED MANIFOLD MAY NOT HELP MATTERS EITHER. BUT WHAT I DID WAS TOO POOR DIESEL AND PENETRATING OIL THRU THE SPARK PLUG HOLES AND DOWN THE EXHAUST PIPE. IF YOU HAVE A HAND CRANK INSTALL IT AND HOOK A COMEALONG TO THE HAND AND APPLY PRESSURE BUT DO NOT OVER TIGHTEN. THE IDEA IS WITH PRESSURE AND THE OIL DOING ITS JOB IT MAY FREEUP BUT THIS WILL TAKE 2-4 WEEKS SO BE PATIENT. KEEP CHECKING THE TIGHTNESS OF YOUR COME-ALONG AND ADD MORE OIL,DIESEL,WHATEVER TO KEEP IT LUBED UP. GOOD LUCK!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|