Farmall & IHC Tractors Discussion Board |
Re: SAE-80 in a Farmall 100???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on August 30, 2001 at 09:28:21 from (63.27.16.195):
In Reply to: SAE-80 in a Farmall 100??? posted by Paul Taylor on August 30, 2001 at 09:20:21:
I think it is the best, but don't get hung up on the number, 80W90, 90wt etc. are OK. Hytran leaks and makes you clash the gears more. Because lubricants have improved so much in the last 40 years, I buy the cheapest I can. Tractors of this age fail from lack of use, lack of lubricant, and water in the lubricant (in that order) rather than from the wrong grade. I put gun grease in the steering gears when there is a seal problem. You get good service and no leakage. Someone else put a zerk in my favorite A and I'm glad. We started putting gun grease in car steering gears in the 60's as gun grease had improved to the point where it was suitable for manual gearboxes.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|