Farmall & IHC Tractors Discussion Board |
Re: Farmall M engine stuck
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zonie on August 29, 2001 at 20:26:42 from (152.163.197.183):
In Reply to: Farmall M engine stuck posted by bama mule on August 29, 2001 at 19:00:58:
I haven't had to unstick a tractor engine yet but I've seen enough posts on this board to give you a starting place. Try removing the spark plugs and shoot some penetrating oil in each cylinder. I've found PB Blaster works as good or better than anything else I've tried. leave the sparkplugs out and jack up one rear tire, put transmission in 5th gear and try rocking the wheel back and forth. Don't force things! If it doesn't break free add more oil and let it set for a week or so then try again. when it does come free you should add a bit of regular engine oil to each cylinder and leaving the pulgs out crank it over several revolutions befor putting plugs back in and attempting to start engine. if you can't get it to break loose this way you may need to pull the head!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|