Farmall & IHC Tractors Discussion Board |
Re: farmall or fairway
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Kerr on August 27, 2001 at 22:00:41 from (205.188.199.167):
In Reply to: farmall or fairway posted by doug schmidt on August 27, 2001 at 16:51:19:
I am no expert on fairways but I think they were nothing more than low highth wheels on a farmall.The wheels were also wider and had no cleats so it wouldn't leave ruts on golf courses or nice lawns on large estates.They were usually used to pull large groups of gang type reel mowers. The only fairway I have ever seen or heard of was an F-12. There may have been an f-20 version but I am really not sure. I am sure some one can add to this. I do know a regular has an open gear for the steering and the later f-12/f-20/f-30 had an enclosed steering gear.That is the quickest and easiest way to tell a regular from an f-20 which are similar in size.Another way is that the regular exhaust comes out of the manifold below the carb and has a large bulb shaped "muffler". The f-20 exhaust goes up striaght out of the top of the manifold.Does the tractor have a serial number plate or a stamping in a raised boss on the side of the block? that will tell a lot.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|