Farmall & IHC Tractors Discussion Board |
Re: Hyd. on an M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M w/photo on August 15, 2001 at 19:24:31 from (66.66.72.246):
In Reply to: Hyd. on an M posted by Tom W. on August 14, 2001 at 18:34:53:
Tom - This is how my Super H (belly pump-equipped - no live pump) is set up - sounds like your M might be similar. The two lines to the rear end quick couplers have been removed and the openings in the control valve plugged, but you can see how the valve is piped up. To operate the rear hydraulics you first pull the belly pump control rod back and latch it in the back position. This then feeds pressure to the remote control valve which you control with it's own rod. Hope this helps - e-mail back if you need additional photos. ...Bob M
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|