Farmall & IHC Tractors Discussion Board |
Re: 656 shifting problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kev@ia on August 15, 2001 at 18:46:22 from (206.72.15.209):
In Reply to: 656 shifting problem posted by Mark on August 15, 2001 at 06:01:54:
Hello Mark, I know what your talking about, dads 544 uses the same shift setup. I made a new shifter shaft and built up some worn areas so that most of the shifting woes were curred back in Dec or Jan. The Quick fix that will help is to remove the casting that holds down the springs on top of the trany and put a short 1/4 bolt with the threaded portion in the spring and the head against the ball so it is under more preasure. Also make a bigger hole in the shaft that runs through the links so that the ball bearing can make nuteral more evident. Get a over length die makers dowl pin and grind to length as it will bear on unworn metal and remove a lot of slop. The factory pin is to short and wears to fast. Check the archives as I posted about this before. Good luck and if you need more help just post for it. kev
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|