|
Farmall & IHC Tractors Discussion Board |
Re: Re: The Restoration Begins
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JDM on August 12, 2001 at 08:13:39 from (206.74.34.183):
In Reply to: Re: The Restoration Begins posted by The Red on August 12, 2001 at 06:35:20:
Well mostly just cosmetic stuff.A few gaskets and seals for those that leak and new rubber all the way around.I got the fenders,seat,steering wheel and the Farmall emblel from SWR,but the gauges and wiring harness are coming from OEM as well as the new serial no. plate.(Ill probably get chewed out onthat but the old one was so far gone I could barely make out the number.A friend of mine took it to his head shop and manafluxed it,I think thats what he done,to get the number.)The engine is an IH repalcement engine from 49 I think,theres no serail no stamped on it but i think the casting code was for a 49.It runs like a top but am having new plugs,points,cap and wires put on anyway.The carb needs building but only because its dirty on the outside and the gaskets leak some when its been running for a while.We had rebuilt the tranny a while back so everything in there is still good but hes going to check it out when he pulls the top to replace the gasket.HE wont get much done over the next two weeks,hes heaed up your way to the Portland show while hes on vacation.Hes going up there to get a axle cap for mine and a few other things for his toys,brags on that show!Says if I could get off work I ouught to ride up there with him!
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
