Farmall & IHC Tractors Discussion Board |
Re: farmall h magneto problems--help!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ThatOtherGuy on August 05, 2001 at 20:50:59 from (216.93.70.130):
In Reply to: farmall h magneto problems--help!!! posted by derek csendom on August 05, 2001 at 20:05:37:
From this 13 yr old's point of view if it backfired the wires were right. My Case SC did that. It turns out that the mag is 180 degrees out of time. Take the mag wires and move them to two more clockwise positions. This is easier than taking the mag off. Take the wires that are across (/) and switch them. Then take the other two (\) and switch them. IF it DOES NOT RUN, switch them back. I'll show you again. 41_____________________23 32 the order of the plug wires. 14 One possible order. Just to remind you the firing order is 1342. On the MAG PART # 1 spot normally goes to #1 cylinder. #2 on MAG PART normally goes to #3 cylinder. #3 on MAG PART normally goes to #4 cylinder. And finally, #4 on MAG SPOT normally goes to #2 cylinder. Dont worry! You'll figure it out. ThatOtherGuy
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|