Farmall & IHC Tractors Discussion Board |
Diesel timing question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Klaus on August 03, 2001 at 08:31:43 from (206.229.91.132):
I have an International 3514 with D-239 engine. The operator's manual states that injection timing should be 14 deg. BTDC static (ingine off)**at the end of the injection stroke** without the start knob pulled. The engine manual says to line up the timing marks inside the pump at 14 deg. BTDC. Alternately (and more accurate) the enigne manual says you can measure the timing at 1.0mm pre-stroke using a dial indicator to measure plunger movement at the delivery end of the pump. My pump's internal timing marks line up at 14 deg BTDC, but I measured delivery timing with a capillary tube at the #1 injector line and find that this is the START of the injection stroke. I have not measured the pre-stroke with a dial indicator. Does anybody have enough experience with these engines to explain the apparent disparity? I guess that measuring pre-stroke may be the only way to find the truth here... Thanks, Klaus
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|