Farmall & IHC Tractors Discussion Board |
Re: Farmall H Oil and brakes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on July 31, 2001 at 17:16:12 from (216.46.140.186):
In Reply to: Farmall H Oil and brakes posted by Donald Andersen on July 31, 2001 at 10:18:23:
Don, just to add to the Red's comments, the adjustment in H brakes is in the yoke only. Make sure you have the screws at the bottom of the brake pan turned all the way in , then let off about a half turn. That holds the brake bands in place. As the Red said the bolt in the yoke might not want to come out. I had to heat mine red hot to move them and I even broke one when it was red hot. After you have freed the adjusters make sure that both sides have the same response, feel if you like, so that both brakes are equalized. When you road test lock the pedals together and you should be able to tell if both brakes are responding together..and if everything is right you should be able to slide the wheels. There is the possibility that the brake bands are worn, but the adjusters should tell the story at a glance. Good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|