Farmall & IHC Tractors Discussion Board |
Re: Questions about paint...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave t on July 19, 2001 at 08:55:09 from (63.20.49.182):
In Reply to: Questions about paint... posted by ff316 on July 19, 2001 at 08:06:22:
What are you going to use it for? How much are you willing to spend? Your Case/IH paint does oxidize pretty quickly, but if it's a work tractor, who cares? If you are painting to show and don't plan to use it, I would recommend the PPG OMNI. It's not expensive as Dupont. Whatever system you use, whether it's single stage, two stage urathane, or enamel from Case, you need to use the correct primer and other stuff needed for that system. You can't use rattle can primer and expect urathane paint to stick.....Your Napa store carries Martin Seniour paint, and your big store can mix up a single stage urathane for you too.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|