Farmall & IHC Tractors Discussion Board |
460 / 560 fender identification
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kev@ia on July 17, 2001 at 19:06:26 from (205.247.198.92):
About a month ago I got a set of fenders for my 61 farmall 460 at auction. They said the fenders were for a 560. There is a raised three hole mount for a rear light and two pair of holel for electrical jack and somthing else, plus they have handels on the front edge made from 5/8 rod and bolted to the fender with IH 3/8 bolts. Would these be for a 560 International? I used 4.5 by 3/8 flat steel to make the mount plates and the fenders lean out about 5 degrees. This is a working tractor and I needed the fenders for safety reasons. If anybody wants to trade say so but the shipping is gonna be your cost. Happy Tractorin!!! kev
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|