Farmall & IHC Tractors Discussion Board |
Re: F12 quit running while at show.....HELP!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by doug on July 17, 2001 at 05:55:32 from (64.12.104.28):
In Reply to: F12 quit running while at show.....HELP!! posted by Brian on July 16, 2001 at 10:29:58:
had the same problem with a 38 f-20,after alot of frustration i discovered rust in the carburetor,mine was at a very difficult to clean out area,where the passage of fuel turns a 90 degree angle(the carb is drlled and then plugged) but when i disassembled it and squirted carb cleaner through each passage (one at a time) followed with compressed air,used a thin wire if not satisfied with results,i found it right between the float valve and the (big) load mixture screw, i did not want to drill out the factory installed plug, so working in these close quarters was in the twilight zone or something, good luck ,if your fuel tank has crud in it, we used bb's like a whole bunch of them,after tank was off to shake around in there and clean it up,well, you have fun now
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|