Farmall & IHC Tractors Discussion Board |
Re: Fasr hitch coupling beams
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on July 16, 2001 at 21:06:35 from (63.44.140.217):
In Reply to: Fasr hitch coupling beams posted by Dale Kite on July 16, 2001 at 18:32:37:
Dale If you have a lot of money to spend then you can get the factory coupling beams. I found some at Berkshire Implement Co. at 219 643-3115 a couple of years ago for 50 bucks each. I called the other day to get another set and the price had gone up to 110 dollors each. These weren't the ones your looking for. they were for some plow and had only 6 inches of beam past the beam stops. You can buy aftermarket coupling beams that have the ball socket pressed in them for 3 point use that look pretty good. I have had pretty good luck going to old tractor/equipment wrecking yards and have found lots of these beams. I have since modified all the 3 point equipment to two point. You just can't beat the ease of hooking up two point equipment.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|