|
Farmall & IHC Tractors Discussion Board |
Help With H Steering!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 1PWRFULH on July 16, 2001 at 15:12:08 from (63.23.233.175):
Ok well I decided today to take a look at the H's steering because at full speed that thing wobbles so badyou just wonder if something is going to break. Took the shaft apart at the u joint and it appears that the worm gear has too much play in it. It allows the rod to turn quite a bit before moving the sector gear. That big plug was as tight as it wuld go and the bearing in there looks fine. I dont think that it is nothing more than those 2 gears. Can I get replacements or what is the easiest way? Is that worm gear made onto that shaft meaning I would have to buy the whole shaft too or not? Everything was covered in soo much grease I couldnt see it very well. I tried turning the gear 180 degrees like I read in the archives but it didnt help. Suppose you are looking at one of the steering wheel spokes when it is straight up the spoke will move about 60 degrees before you start turning the wheels. I have a feeling these gears cost a lot and should I rebuild the bottom while I'm at it? Well thanks!! RC
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
