Farmall & IHC Tractors Discussion Board |
Re: Baler for Farmall C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Kerr on July 16, 2001 at 08:39:05 from (152.163.197.53):
In Reply to: Baler for Farmall C posted by Luke Petre on July 14, 2001 at 10:41:35:
I picked up a new holland 68 baler a week or so ago and baled some wheat straw the other day using my F-12. The power was there to run it ok. I did have to pull it in low gear but I was also pulling a hay wagon behind the baler. I did find out that the wooden bearings on the plunger(hard maple slides) were wore out and the plunger knife was over 1/4 inch away from the stationary knife. What came out was banana shaped bales!The knife was not cutting and was pulling in extra material and it ended up on the right side of the bales.I just called a NH dealer and the wood bearings are still available for $19. each. My advise would be to look closely at the baler you are thinking about and check out the adjustments. If they are adjusted all the way over and things are still loose, then the baler may be ready for complete overhaul. Check the chain adjustments and also look at the adjustments for the plunger slides.It can be loose side to side and top to bottom. A sloppy baler will make sloppy bales. I am going to go ahead and rebuild my NH 68. When I am done sinking cash and making some new parts, it should last me another 45 years like it did the original owner with very little future repairs. (I hope anyway!)
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|