Farmall & IHC Tractors Discussion Board |
Re: Re: H rear hubs , axles and seals
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on July 11, 2001 at 17:57:27 from (216.46.140.186):
In Reply to: Re: H rear hubs , axles and seals posted by George Willer on July 11, 2001 at 09:26:38:
George, both H's have cast wheels and the one I was working on is identical in appearance to yours. The other H I have at home in my shop has cast wheels as well and the wheels are identical on both tractors, the difference is one tractor has a one piece hub block the other has two hub blocks approximately 2"+ wide in place of the single, they bolt up to the wheel the same way and could easily be interchanged. Some one suggested that two piece could be a later hub block like on the 300's...who knows! It looks like you got a real nice paint job on your H. Thanks for your response.....Mike in Exeter ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|