Farmall & IHC Tractors Discussion Board |
Re: B with frozen motor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on July 09, 2001 at 20:21:08 from (128.242.4.59):
In Reply to: B with frozen motor posted by Will on July 09, 2001 at 10:03:56:
Sounds like you have alot of tips here Will. I have freed up a few myself. I have never used pb blaster. One thing I heard of was good to use for soaking is automatic transmission fluid. I used this on a couple that were mildly stuck and it worked pretty well. Didn't know about it when I was working on the really frozen ones so haven't put it to the real test. As far as the breaking over, if they are froze really good, blocks and jacks and hammers is the best way I know. Just a little tip on the wood blocks is to use really hard wood such as oak. This will keep you from widdeling down a few blocks because they can take more abuse. If the sleevs are pitted then you are going to have trouble getting the piston to come up out of there even if you get it free. if that is the case you have to go down with it or take it out with the sleeve. I hope you get it freed up.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|