Farmall & IHC Tractors Discussion Board |
Need front loader for 240 Utility
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom Lassiter on July 09, 2001 at 19:00:14 from (63.102.170.99):
I am looking for a front loader for a 240 Utility.(from N.C., so the closer the better) My tractor has a hydraulic pump and 2 wet lines on the side (used to have a sickle mower). Is this all I will need, other than the front loader itself, to have a functioning loader? Or will I need an additional set of lines? I would prefer to find a used loader, but are there new aftermarket loaders that will bolt up? Also, I read somewhere that the 240 Utility came with either 2 or 3 point hitches. Mine has neither, but does have bolt patterns where something went. I would like to have a three point hitch, used or new. Any help will be most appreciated. Also, what would be fair prices for these pieces used ?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|