Farmall & IHC Tractors Discussion Board |
Re: Rear Oil Seal on an H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on July 09, 2001 at 13:46:27 from (209.130.148.25):
In Reply to: Rear Oil Seal on an H posted by Kevin on July 09, 2001 at 11:34:05:
Changing the seal isn't rocket science but it is a lot of work. You will need to split the tractor to get to it. If you have a belly pump, remove it and take out the clutch before splitting the tractor. You also need to disconnect the steering, gas line and throttle. You also have to remove the starter and the oil pan. Splitting the tractor means needing to support both ends. Once split you will need to remove the fly wheel. After that you will see the retainer for the seal. It goes a lot easier with some help. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|