Farmall & IHC Tractors Discussion Board |
Tranny on B and H Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 1PWRFULH on July 09, 2001 at 08:49:36 from (63.23.233.52):
Ever since I bought the B I noticed that it grinds a lot going into gears. If I have the tractor idling, then push the clutch in, and wait an wait it will still grind a lot. The H, the C, a 230, and the B275 dont grind that much. Like on the H if I get someone to push the clutch in and I get up under it and look, everything stops turning within a second or two. It seems though as if the B takes a lot longer and still grinds sometimes. I tried adjusting that threaded rod on the clutch thinking it wasnt throwing out quit enough but that didnt seem to help. Does anyone have any suggestions to what could cause this? Could it may be that it is low on tranny oil? Also, if I tear the front end of the H off because it wobbles a little in high gear would I be able to get all of the parts I need? Thanks!! RC
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|