Farmall & IHC Tractors Discussion Board |
Re: Farmall B width
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave BN on July 05, 2001 at 15:44:15 from (64.12.103.177):
In Reply to: Farmall B width posted by Steve K on July 05, 2001 at 08:36:03:
Steve, the rear wheels are adjustable in 4" increments (2" each side) from 64" to 92". I believe that is measured from the center of the wheel as they don't know how wide of tires your going to have. Adjustments are made by bolting the lugs of the wheels either on the inside of the hubs (Narrow) or the outside of the hubs(Wider). You then swap the wheels from one side of the tractor to the other (notice that the lugs are not centered on the wheel. The 3rd width adjustment is made by turning the hubs inside out(dished in or out). Combinations of these 3 adjustments give you 8 different widths. Sorry if this is more info than you wanted. Dave.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|