Farmall & IHC Tractors Discussion Board |
Re: Camber or caster
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George Willer on July 04, 2001 at 07:05:28 from (64.254.131.14):
In Reply to: Camber or caster posted by Dick A on July 03, 2001 at 06:05:38:
It is natural to assume the wide fronts and narrow fronts have camber for the same reasons. You will really impress your wife if you explain the difference. The narrow front has camber simply to get the bottoms closer together for easier steering, while still allowing clearance at the top for the pedestal. The wide front is a different case. The camber and king pin inclination working together cause the tractor to rise when in a turn. The weight of the tractor causes the wheels to tend to return to straight ahead. (because it is lower then) We are so used to this effect that we don't even notice it, but without camber, the steering would wander badly. You will notice it if you note how much easier it is to return to straight ahead than it is to turn. Camber and inclination working together also put the point of rolling resistance in line with the king pin. George Willer
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|