Farmall & IHC Tractors Discussion Board |
Re: Re: Camber or caster
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on July 03, 2001 at 07:13:54 from (38.31.74.103):
In Reply to: Re: Camber or caster posted by RAW in IA on July 03, 2001 at 06:44:32:
I agree. With wide front ends, the centerline of the pivot goes throught the tire contact point on the ground. On old trucks, you could see the kingpins angled so the center of pivot was in the tire footprint. It is still there with ball joints wut harder to see. Caster refers to the center of the footprint being behind the center of pivot, just like a caster on a table, pull the tractor forward and the wheels will straighten up. Add toe-in and alignment is complete.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|