Farmall & IHC Tractors Discussion Board |
Re: Spin-On filters?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny Frisk on June 29, 2001 at 10:38:56 from (12.4.181.2):
In Reply to: Spin-On filters? posted by Brent on June 29, 2001 at 09:12:40:
Don't change the O-RING. Once You get the o-ring in and seated in the groove when You change the filter just tighten the thru-bolt slightly, run the tractor till it warms up and if it leaks just tighten it up till it stops leaking. Turn the filter cover before it gets snug to make sure it finds the old groove it made in the gasket. From snug to leak-free shouldn't be over 1/2 a turn of the clamp bolt more. That's the way Dad & I have done it for the last 50+ yrs.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|