Farmall & IHC Tractors Discussion Board |
Re: 1951 international 300 farm tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny Frisk on June 29, 2001 at 06:55:10 from (12.4.181.2):
In Reply to: 1951 international 300 farm tractor posted by Elmer on June 29, 2001 at 05:15:20:
If factory Power steering IS on the tractor You should be able to see the unit above the back of the engine way up inside the hood. Big cast iron unit about 15 inches long with the steering shaft running into & out of the unit. It's powered by the live hydraulic pump mounted between the timing gears and distributor on the right side of the engine as You sit on the seat. Power steering wasn't common on the 300's. Most 350's I've seen have it. If it has add-on P/S the separate pump "MAY" be installed on the upper left side of engine right behind the radiator. The steering unit would be in the same place, only smaller, about 9-10 inches long and 3-4 inches in dia.. It too may be plumbed into the live Hyd. system for power. Red's correct on the model years. '54 & '55 for sure. I'm not sure exactly when the 350 was introduced, in '55 or '56.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|