Farmall & IHC Tractors Discussion Board |
Re: I've Gone Done It!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on June 27, 2001 at 19:56:43 from (129.37.117.155):
In Reply to: I've Gone Done It!! posted by Bama Red on June 27, 2001 at 14:48:52:
We had a three disk turning plow on the Farm in Missouri where I grew up. We used it on the MD. It looked different than yours. Ours was a mounted plow and had a hydraulic cylinder that was used with the Lift All to lift it. It could be converted to a 2 disk plow by just removing one of the disk assemblies from the beam and moving the rear wheel up. I don't recall ours having that big wheel on the front that is on yours. Is yours a mounted plow?? Ours attached to a bar that was mounted under the tractor about where the Lift all pump is located or slightly behind there. As I recall, it took about a half a day work to get the thing on the MD. I think you had to remove the drawbar and the plow had attachments to the axle as well as under the tractor. It also had a long bar that went to a bracket mounted on the front wheel assembly of the tractor that steered the back wheel of the plow. It did a good job of plowing. Sorry to hear you have to get rid of the M. After all that work on the tires too!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|