Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: oil pan leak
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on June 26, 2001 at 10:08:31 from (192.232.119.194):
In Reply to: Re: Re: Re: Re: oil pan leak posted by Todd on June 26, 2001 at 08:59:24:
Todd - So long as the pan flange is flat within 1/8" or so, I've had good luck sealing slightly warped pans with Permatex red silicone gasket maker. Start with the pan flange, mating face on the block and the gasket thoroughly clean and degreased. Run a bead of silicone about 3/16" diameter all the way around the pan flange, keeping it to the inside of the bolt holes. Position the gasket over the flange, line up the bolt holes and lightly press it into the silcone. Now run another 3/16" bead all the way around the upper side of the gasket. Finally carefully position the pan and bolt into place. Wipe off the excess silicone that gets squeezed out, then give it several hours to cure before adding oil and starting the motor. I've found a couple long (6" or so) bolts - same thread size as the pan cap screws - are helpful holding the gasket in place when postioning the pan against the block. Also be careful to not overtighten the pan cap screws - you just want to good bead of silicone squeezed out out all the way around the outside edge of the flange. Seems to me 10 - 15 ft-lbs on the cap screws is enough. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|