Farmall & IHC Tractors Discussion Board |
Re: Re: Stumped on C problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by FC on June 25, 2001 at 11:01:10 from (208.14.16.15):
In Reply to: Re: Stumped on C problem posted by Curt Cooke on June 25, 2001 at 07:32:14:
Thanks Curt....You have made me wonder about the switch. It is an aftermarket, and has given indications of going bad. I do not have another tractor which I can switch parts from though. I have a 'factory' switch which I believe to be good, and may try that, and I think I will go buy another coil to try also, and return the one on the tractor. I may be paying the price for going "cheap" on the coil and gotten a defective one. I did check for 6 volts to coil prior to replacing it and did in fact have a "dead" coil. The part that makes me suspect coil is that it ran fine prior to the dead coil.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|