Farmall & IHC Tractors Discussion Board |
Re: B fluid level
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by haas on June 20, 2001 at 05:12:02 from (129.37.117.73):
In Reply to: B fluid level posted by greg central wis on June 19, 2001 at 19:30:12:
I think the B is like the A. ON the A, the level plug is located on the left front of the transmission housing. It's a 1/4 or 3/8 in pipe plug. On the A it is behind the left brake rod and and you need to disconnect the brake rod to get to it. Fill until oil comes out the hole. The fill hole is on top the transmission near the gear shift. The final drives are separate and need to be changed separately. If like the A, there is no drain on them. You have to remove the pans that cover the bottom of the bull gears. Go get new gaskets before you do that. The fill plug and the level plug are the same on the final drives. Fill until oil is to the bottom of the fill plug. The fill plug is a 1 inch pipe size plug located on the inside of the final drive near where the drawbar bolts on. It has a recessed square hole to stick a square wrench in to remove it. A 1/2 inch drive socket ratchet or breaker bar works good for a wrench to remove the plug.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|