Farmall & IHC Tractors Discussion Board |
Re: IH 460 brake pedal bolt
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Moose on June 19, 2001 at 11:41:37 from (12.78.129.249):
In Reply to: IH 460 brake pedal bolt posted by Mark on June 19, 2001 at 09:05:47:
I forget what the 460 rod looks like, but if its like the 240, with an open clevis at one end of a threaded rod, I've patched together several over the years. Get a hardened bolt with the same threads (find one with as much thread as possible) and figure where to make your cut for welding the two together. Use the broken rod against the broken yoke to figure where to cut and splice, remembering you need enough threads for proper brake adjustment. Taper grind the ends and start welding. I suspect you can still get the bolt from Case/IH. One of the 460 guys on here can help with that info.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|