Farmall & IHC Tractors Discussion Board |
Re: What is the carb adjustment procedure for the Farmall 560
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on June 13, 2001 at 20:28:42 from (216.196.13.206):
In Reply to: What is the carb adjustment procedure for the Farmall 560 posted by Will on June 13, 2001 at 14:14:59:
If it was me i would go the whole route and start with a valve adjustment then a new set of plugs , points and condencer cap rotor and wires, set the timing at idel and at full throttel then set into fine tuneing the carb, first set the idel and then start setting the idel mixture screw to the best setting that i could get then set the main screw to about four and a half turns off the seat. When setting the idel mixture screw keep backing off the idel stop screw till you get the best at the lowest idel then set the idel back to specs.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|