Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Farmall BN Stuck Clutch


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Bob M on June 13, 2001 at 05:06:56 from (66.66.72.246):

In Reply to: Farmall BN Stuck Clutch posted by Dave on June 12, 2001 at 20:04:08:

Dave - First make sure the clutch linkage is properly adjusted (about 1" of free play measured at the pedal). If you have another tractor to pull with, do this: Remove the coil wire and put it in your pocket (so the motor can't start...) Then put the transmission in 4th gear, depress the clutch pedal ALL THE WAY and pull the BN forward 10 or 20 feet - the motor should spin. Now unhook, go around back of the tractor and pull it backward the same distance. After a few repetitions of this back and forth pulling, the resulting torque reversals on the clutch will often break it free.

If you don't have something to pull with, this has worked for me too: Start the motor, let it warm up a few minutes, then idle it as slow as possible. Get the tractor onto hard, level ground. Now "snap" shift the transmission into 1st gear - if you do it right it won't hurt the transmission. The tractor will now be moving forward slowly. Then snap shift up into 2nd, 3rd and finally 4th (motor still at low idle). Once your in 4th, open the throttle, step on the clutch and stand on both brakes. (Helps if you do this part while going uphill - you're trying to get as much load as possible on the motor/clutch...) If you are lucky the clutch will break free.


Follow Ups:




Post A Followup

:
:

: Re: Re: Farmall BN Stuck Clutch

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy