Farmall & IHC Tractors Discussion Board |
Re: Started the Farmall H up after 10 years!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red. CONGRATS! on June 11, 2001 at 09:10:52 from (206.246.187.2):
In Reply to: Started the Farmall H up after 10 years!!! posted by Scott S. on June 11, 2001 at 08:44:04:
Scott on the tranny plug, use a 3/4 inch extension on a rachet. It will open it up. Make sure you clean that area before taking out the plug. I drain the Hs in 3 places. The obvious one is the rear plug under the PTO. The front drain plug is under the liftall cover plate. You will get a couple of quarts from that drain plug. If you have a flat belt pulley, loosen up the 4 bolts that hold the face and pulley in the casting. Tap the pulley out about 1/4 inch. You will get a good quart of oil and WATER from there. I usually let the H drain for 24 hours. When you get ready to refill with 6 gallons, save 1/2 quart to fill in the filler plug on top of the flat belt pulley.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|