Farmall & IHC Tractors Discussion Board |
Re: can Quicklift be used in super M transmission
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on June 09, 2001 at 20:16:14 from (63.44.140.31):
In Reply to: can Quicklift be used in super M transmission posted by Sam on June 09, 2001 at 20:00:36:
I don't see why it would hurt. The book for my 400 Diesel says to use hytran which is really hydraulic fluid, same a quick lift. The only difference in the 400 trans is the TA. So if you want to, go ahead. I had my TA rebuilt using the heavy duty sprague lock up and the Mechanic told me to use 80/90 weight. So I use 80/90 in all 4 of my tractors. 400 and 300 Farmall, 300U and 600 International and I haven't any problems at all.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|