Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: Possible voltage problem w/coil w/res + res. wire in harness
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M - yup....makes sense... on May 27, 2001 at 18:26:44 from (66.66.72.246):
In Reply to: Re: Re: Re: Re: Re: Possible voltage problem w/coil w/res + res. wire in harness posted by Red Dave - Bob M. what do you think? on May 27, 2001 at 18:04:07:
Hey Red Dave - Your logic makes sense - I think you've correctly diagnosed the root of Gene's problem! Another way to check would be to take a voltage reading with the ignition on and the motor NOT running. Measure between the coil "+" terminal and a good ground. With the jumper in place the meter should read battery voltage (12.6 or so), and with the jumper removed about 7 volts. This would account for the weak spark since the coil wants a 12 volt input, but is only actually getting 7 volts. Can also try running the tractor with the jumper in place - I'll bet that solves the problem. Solution then would be to install a "6 volt" coil in place of the internally resistor-equipped 12 volt coil.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|