Farmall & IHC Tractors Discussion Board |
Re: Re: HELP, Trying to Adjust Wide Front End on Farmall A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George 2 on May 27, 2001 at 15:05:59 from (216.46.140.186):
In Reply to: Re: HELP, Trying to Adjust Wide Front End on Farmall A posted by george Willer on May 27, 2001 at 05:48:10:
I had the same problem with a Farmall 504 wide front. It was out in the widest position and I wanted to move it in. I took the clamps off, put a smaller bolt (1/2 inch diameter) in the pin hole, dosed it with WD40 and then ran it up and down a washboard gravel road in high gear. After about 15 to 20 miles of gravel road, I tried to push the front of the tire against a tree. At that point I noticed the first movement. I then straddeled the tractor around the tree and pushed against the back of the tire. More road, more pushing, and more WD 40 and finally it was free enough to move. This procedure was then repeated for the other side. It took over a week, off and on to get both sides freed up. I do not recommend heat, and I replaced the tie rods on one side because they were not only stuck but also bent.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|