Farmall & IHC Tractors Discussion Board |
Re: Steering bolster pivot removal on a H...help!!!! Bob M. or anyone?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doug D....just did that job. on May 24, 2001 at 16:59:28 from (206.62.210.245):
In Reply to: Steering bolster pivot removal on a H...help!!!! Bob M. or anyone? posted by Zonie on May 23, 2001 at 22:27:26:
Just did this a couple of weeks ago, and had the same problem. This is what I did. Screw that gear up on the threads so that the top of the shaft and the gear are flush. Then, I took a piece of HARD wood, not soft pine or the likes, lay it on top of the gear and shaft. Then I stood on a bucket and whacked on it with a 5 lb. hammer. Don't beat the life out of it, cause you may miss and that would be bad on something. That piece of hard wood is forgiving enough not to do any damage to any casting or shaft. It took several whacks, but it came and no damage was done. Good luck, if you need more info, ask.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|