Farmall & IHC Tractors Discussion Board |
Re: Proper Torque Specs. for Manifold and Head on a Farmall C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on May 24, 2001 at 05:52:38 from (129.37.117.166):
In Reply to: Proper Torque Specs. for Manifold and Head on a Farmall C posted by Fatback on May 23, 2001 at 20:23:03:
Don't know about the manifold. I had some leakage from the head gasket on my C. Folks on this forum said the correct torque for the head bolts was 65 ft-lbs. I asked the IH dealer and he said 80 ft-lbs. Don't know which is correct, but I tried 65 ft-lbs first. The bolts all moved at around 40-50 ft-lbs, so they were not tight enough. However, the leak did not stop until I went to the 80 ft-lbs.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|