Farmall & IHC Tractors Discussion Board |
Re: Steering bolster pivot removal on a H...help!!!! Bob M. or anyone?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on May 24, 2001 at 04:37:11 from (192.232.119.194):
In Reply to: Steering bolster pivot removal on a H...help!!!! Bob M. or anyone? posted by Zonie on May 23, 2001 at 22:27:26:
Zonie - The pivot shaft on mine fell right out soon as I removed the nut. But the bushings were quite worn so there was nothing to hold the shaft. You probably have good bushings and it's a tight fit for the very top (unworn) end of the pivot shaft to slip thru the upper bushing. Red's suggestion to use an extension to pound on the shaft is a good one - just be sure to protect the relatively soft pivot shaft threads so you mushroom them over. Use a piece of brass bar stock, or steel bar stock and stick a piece of softer metal (like a penny) on the end of it to protect the pivot shaft threads. Suggest putting a jack, a pile of wood block under something under the pivot shaft flange. It weighs 20+ lb - when it comes free you won't want it landing on your toes! Good luck! ...Bob M PS - Did you buy a new sector gear?
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|