Farmall & IHC Tractors Discussion Board |
Re: Rebuilding steering on a Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by David A on May 21, 2001 at 10:38:43 from (12.26.113.4):
In Reply to: Rebuilding steering on a Super A posted by marvin on May 21, 2001 at 07:17:53:
I don't think JB Weld would hold up to the oil or loads. Now that you've done the hard work of getting the box out, if it were me, I'd try fix it once and for all. I'd take the shaft, gear, and key to a machinist and have him do the work it takes to get a real good fit. On the tapered shaft, I take it that the nut runs out of threads before getting tight? A washer might help this. You also should try and minimize up and down end play as you assemble the shaft in the box. That will also contribute to steering slop. Mine has some of this end play and I don't know how it is adjusted (shim washers or what). I'd be interested in what you find. David
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|