Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Need Some Advice on Starting an Old H


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Bob M on May 20, 2001 at 18:36:28 from (66.66.72.246):

In Reply to: Need Some Advice on Starting an Old H posted by Bama Red on May 20, 2001 at 18:05:41:

Bama -

What you've got is an H originally setup to run on distillate (hence the small gas tank for starting)

I've fired up several H's and M's that have been sitting idle for several years. Here's how I've done it:

1 - Check the crankcase oil level. If it's down, or the oil looks questionable, drop the old oil and replace with fresh. Also put in a new oil filter.

2 - Remove the spark plugs and shoot an ounce or so of motor oil (several squirts from a hand oiler) into each jug. Leave the plugs out for now.

3 - Connect the battery and try cranking. If you are lucky the motor will spin. Crank it until oil pressure shows on the gage, then crank it another 30 seconds or so to distribute oil up into the valve gear in the head. Keep an eye on the starter - let it rest if it starts warming up!

4 - While you're cranking, listen for the mag impulse coupling to "snap". If it snaps - great! If it doesn't, take it off, clean it, oil it up and put it back on.

5 - Remove the sediment bowl and clean it out.

6 - Dump a couple gallons of fresh gas into the large tank. Open the fuel shutoff a moment to make sure fuel flows, and to flush out any crud.

7 - Replace the sediment bowl (use a new gasket on it - the old one is guaranteed to leak!) Now open the drain cock on the carburetor, then open the valve at the sediment bowl. Again if you are lucky you'll get some gas draining from the carb. If not, you're gonna have to open the carb to clean it or fix a stuck float.

8 - Finally replace the spark plugs. Set the governor at 1/2, pull the choke and crank her up. If you're having a good day you'll be rewarded with a running H.

9 - If it fires up, don't let it run more than a minute or two until you've filled the cooling system with water.

Good luck! ...Bob M

PS - Before you do anything, check for wasp nests up under the hood, in the clutch housing, behind the radiator, etc. Otherwise you may be in for a NASTY surprise! (I've been there a couple of times...)


Follow Ups:




Post A Followup

:
:

: Re: Re: Need Some Advice on Starting an Old H

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy